Tag: counter

Defending “Bash” Concepts

Defending “back away” concepts with a four man front.

The modern Spread offense is nothing more than the natural evolution of traditional schemes found in most Flexbone or Wing-T offenses. The main difference is the addition of multiple wide receivers and the location of the quarterback (gun or pistol). Take the traditional double slot look of the flexbone, add a couple receivers as the slots and spread them out, back up the QB to five yards and an offense now has the Spread’s 2×2 look. The plays that run from this particular set look similar to the Flexbone’s veer plays, obviously with some tweaks. The Triple’s Dive Option is the Spread’s Zone Read. The use of a different formation and location of the QB changes the conflicts of the defense. Running from the “gun” backfield allows the offense to have a full field range of reads. Utilizing pistol or dot (UTC – under the Center) leaves half the field to read and an offense cannot use a RB stretch path to challenge the defense’s fits.

A different defensive approach must be taken when defending an offense that runs from the gun compared to a team that primarily aligns from the pistol or dot. RBs in a pistol/dot backfield are forced to go downhill. Many defenses spill gap runs when defending these “downhill” formations. The best way to defend a downhill running team is to make the play bounce (or spill). When facing a gun offense, defenses must adjust the traditional run fit rules because the RB can easily bounce the play wider than his initial aiming point. The field of vision for the QB is also affected by a gun alignment compared to play designs from a Pistol/Dot alignment. From the gun alignment, the QB has a full field of vision, and the offensive coordinator can choose from a number of defensive players to read. The pistol/dot alignment cuts the field in half, allowing the backside defensive players to be more aggressive to the ball (see image below).

 

Running from the gun allows the offense to attack a defense horizontally as well as vertically. The full plane attack by gun backfields forces traditional defenses to adjust the way it defends the Spread, primarily adjusting the play of the defensive ends. In a pistol/dot alignment the offense must attack the defense either vertically (downhill run/gap runs) or horizontal (wide zone/buck sweep/speed option). The full plane attack of the gun backfield allows offenses to run concepts where the offensive players have the option to attack downhill or stretch to the sideline, utilizing the whole field. These particular plays are known as Bash concepts, or “Back Away.”  Continue reading “Defending “Bash” Concepts”

5 Tips For Blitzing From The Secondary

MQ discusses 5 things to remember when blitzing from the secondary.

Utilizing the secondary in blitz packages is one of the most underutilized tools in a defensive coordinator’s toolbox. As many DC’s will point out, blitzing from the secondary will expose the defense to man-to-man coverage, but if used correctly (and in the right situations) a secondary blitz can hit home. When offenses create pass protection schemes they use the box numbers in front of them to divvy out responsibilities. Whether it is Big-on-Big (BOB), slide, or zone protection, the secondary is rarely accounted for in pass pro. Knowing this, and utilizing the secondary in pressure packages, can give the defense an added advantage and lead to QB pressures or sacks.

Using the secondary near the box is not only for the pass. Much like pass pro, some offenses do not account for the secondary in the box. This can be used to the defense’s advantage. Putting a secondary player near the box and knowing he will not be accounted for is an automatic win for the defense. The use of “trapping” the secondary near the box can also be used to confuse “check-with-me” teams. By placing a secondary player near the line of scrimmage (LOS), the offense must decide if the defense is blitzing or will drop the player back into coverage. By utilizing the secondary in pressure packages a DC can create a simple confusing alignment that offenses have to respect. If done right, using the secondary to leverage the boundary can add to the box numbers without spinning to single-high and exposing the defense to verticals down the seam (or a LB guarding a speedy slot WR).

Below, MQ explains 5 things to remember when blitzing from the secondary:  Continue reading “5 Tips For Blitzing From The Secondary”

“How Do You Play Trips?” Pt. 3 – Defending the Run

Defending a spread offense’s 3×1 package run game from a two-high shell.

When developing a defense it is important to start with the front and work back. Lining up correctly to formations, understanding keys, and developing a plan to stop the run all starts with the front seven. In a 4-3/4-2-5 (or 3-4 Hybrid) defense, the secondary players become the adjusters. Playing a single-gap defense and using formations to dictate alignments allow defensive players to see the formation quicker and align correctly. Each player in a defense is anchored to one another in some way. Understanding these anchor points, and how they change depending on formations, is crucial to the success of any defensive unit.

The Spread’s utilization of space has put aligning correctly every play at a premium. It is easy to align to a simple 2×2 formation, but when offenses utilize 3×1 formations (primarily Trips Open) the defense must understand how it adjusts will dictate their areas of weakness. Offenses make use of Trips formations because it forces the defense to give something up. To gain a six-man box a defense must spin, either to the Trips or away.  Continue reading ““How Do You Play Trips?” Pt. 3 – Defending the Run”

Defending Split Zone

Ideas on combating a simple yet effective play.

Inside zone is not a new play to defensive coordinators; neither is the split zone, but it can give defenses fits if not fit up correctly. In its simplicity, it is a creative play to challenge a defense. Unlike its zone counterpart, the split zone creates an extra gap. The play itself is much like the counter without the pulling guard. When offenses run counter the linebackers can react to the pulling guard and fit the extra gaps. The split zone forces the linebackers to fit their gaps. This puts pressure on the secondary (mainly the safeties) to ensure their fits are correct.

In the clip below, Iowa St. runs a gap plug blitz and the defensive end to the H-back runs up the field to hold the “C” gap. The out block by the “H” creates an extra gap. The safety to the play should have fit the inside shoulder of the “H” because the DE was taking the outside. Instead, the safety stays outside and is blocked out, leading to Baylor’s first score of the day. Bottom line, Split Zone has to be treated as though it is a gap play (think power/counter) or a defense will be gashed.

Teams that run inside zone are looking for the cutback. Versus a zone play, the linebackers have to fill their gaps (there is no puller). The offensive line creates a wall and allows the running back to cut back to the open weak side. In the clip above, ISU was running a run stop blitz, but because the safety didn’t fit his gap, it led to a touchdown.

Teams that run split zone and the read-option offshoot, need to be played as though they are gap scheme heavy teams. Add RPO’s to this play, and it puts tremendous pressure on a defense, all from a simple zone scheme. There is hope, much like the Zone Read, a defense can attack this play on the principles of the offense. Continue reading “Defending Split Zone”

Defending Power Football From A Hybrid Defense

Transition seamlessly from defending the Spread to stopping Power football.

Multiplicity

There is not a more difficult time than the present to be a defensive coordinator. The amount of offensive formations, schemes, and alignments has never been greater. Present day defensive coaches can see an offense that bases from an Empty set (3×2/4×1) one week to a Power set (2×1 with two backs) the next. When changes in the offensive scheme are so drastic week to week it is easy for a defensive coordinator to find himself changing his base every week. Below is a look at a modern day “Power” formation – 21 personnel with the two backs stacked strong.

Pro Right Strong

With the explosion of spread offenses around the country, the Power sets are becoming less prevalent. It is difficult for a 4-2-5 team to play a wide-open Spread team one week, only to turn around the next week and face a smash mouth Power/Counter team the next. It’s not only a completely different offense but mindset as well. With a good set of base rules, a DC can seamlessly maneuver the nuances of defending modern football any of the multiple formations thrown his team’s way.  Continue reading “Defending Power Football From A Hybrid Defense”

Fitting up 20p Two-Back Power

Defending traditional two-back power sets.

Run Fits versus Two-Back Power

The power run game is not dead. As spread offenses proliferate through all divisions of football, the “Power” play is still a staple of many offenses. Defenses must be able to adapt to any formation without subbing players because of the tempo being thrown at them. This can cause a dilemma when a defense’s base scheme is a 4-2-5. When teams insert an “H”, or fullback, a defense does not have to spin to a single-high in order to gain an extra man in the box. Instead, use the natural structure of the 4-2-5/4-3 Hybrid to the defense’s advantage.

Continue reading “Fitting up 20p Two-Back Power”

%d bloggers like this: